Gold Plated RCA Phono Splitter - 1 Plug 2 Sockets Audio Y Adaptor Right Angle PAIR PHOSPL01

Product Information

The phono switchers Graham pointed out would seem to be by far the cheapest and easiest option, I don't understand why you seem to have ruled these out? Okay you have to move 2 switches rather than 1 because they are only 3 wide but that doesn't seem such a hardship. How about 2 of these? They are push button which should be easier for you to switch and don't look too bad from the front - it looks like they switch 5 phonos which is unfortunate as you need the extra one for the .1.

Optical Box E Phono – Pro-Ject Audio Systems Optical Box E Phono – Pro-Ject Audio Systems

Most often the computer is the source, it play music into the amp. That is sound comes OUT of the computer and goes INTO the amp. Required because my AV receiver doesn't support HDMI. I might just live with one source via optical and foregoe HD audio on there for the time being - until I can afford an HDMI amp.Just in case I can achieve my aim with what I've bought from Maplins, I'll post below what I bought. Maybe you or somebody else can suggest a specific combination of usage to achieve mono properly on one on my duplicated stereo feeds. I appreciate however that may not be possible. Yeah, I can understand that. It's why I personally chose to go with the hard. There are a few fine cable makers that make soft splitters from their own designs. My reasoning, valid or not, was that to ensure the best sound I'd need to use products from the same maker and of the same design if I went that route. Also that route can be more expensive. Not saying I'm right in my thinking it was just my logic path. I saw the below product yesterday, but anybody know if I can get one here in the UK? I might have looked in the wrong places. This provides isolation between the left and right inputs so the preceding splits are not mono'ed up as well.

Phono Splitter Boxes | Compare Side By Side (September 2020) 10 Phono Splitter Boxes | Compare Side By Side (September 2020)

I don't want to majorly derail anything that may be going on in this thread, but I came here about to start a thread on how to make stereo into mono using phono RCA connections and cables, so this topic caught my attention.

I was originally looking high and low for a stereo/mono switch to put into 1 of the 2 existing feed chains, which would have been fine, but I couldn't find one. A simple splitter has three phono connections on it, one in, two out. All three are simply wired together so the two outputs are a dead short circuit. Which is why if fails miserably if you use it in reverse as a combiner. If you connect two outputs to the splitter then you short circuit the pair of them. What's 'right' here is a simple question of not doing something that will reduce sound quality, ie introduce distortion. That's trivial to ascertain and is not a subjective matter. And *anyone* can reach the same answer, it's NOT a personal thing at all. If all you can advise is 'try for yourself and see if you like the result' then that is NO advice at all. The guy doesn't want to do that, or he would not have asked in the first place.

Gold Plated RCA Phono Splitter - 1 Plug 2 Sockets Audio Y

We have collected the best splitter boxes for your daily purposes after careful scanning and comparative studies between 100’s of products. Our final collection has the best products and we also worked hard to maintain variety within our selection to accommodate personal preferences. We regularly update ourselves with the advancements in these splitter boxes since 2 years. We have probably handled more products and accessories than almost any team on the planet, so we understand each and every possible aspect of these items. If you often find yourself confused about high-value and low-price splitter box, Syncwire Phono Splitter Box is your solution. The syncwire phono splitterbox is constructed from sandblasting, anodizing and laser engraving, which make the connector able to resist pressure. You can wind it without having to worry about knots or kinks. And, this is made of tpe and bulletproof wire, and has anti-sway up to 5000+, which protect the cable from being broken. IMO some did and some didn't. Or at least I didn't seem to notice if they did. I found a preference for the hard type of high copper content. In fact I'm using these in my system now. I've found that the vast majority of hard splitters are brass. The higher conductive metals are too soft and expensive in general. The LATs that I use are of the highest copper content I've found so far. I'm not advocating hard splitters they're just my personal preference so far. YMMV.

Most buyers opine that the splitter box is good for splitting a speaker between 2 inputs. In addition, a few say that the splitter box allows 3 inputs plus it is easy to use and sturdy. Moreover, they say that the splitter box is good quality for the money. Also, this product has a good strong build, looks good and does the job. In conclusion, buyers found this to be one of the best splitter box for daily purposes. http://www.altex.com/%2F35mm-Stereo-Extension-Cord-w-Volume-Control-Mono-Stereo-Switch-10-70-023-P143136.aspx Simply get whatever length you feel you need for your setup. If the computer is close to the amp, typically 1 meter is sufficient. Likely both your Receiver and Computer are STEREO. In this case why would you want to run mono? Which is what you are implying. You are implying fanning one source connector out into two mono connections? Why? I've used splitters myself, both hard (like you linked) and "soft". By soft I mean the spliiter is a cable design that splits as opposed to having a hard body. Such as this.

Phono Splitters | CPC UK

Most buyers agree that the splitter box is easy to use, sound quality is just fine. They say that the splitter box is designed for customers having several audio sources and outputs. Top Customer Quotes: Could be a BD player with onboard decoding, and a SACD/DVD-A transport, both connecting to an older pre-HD audio decoding amp. Most customers found that the splitter box has to be squished right up to each other. In addition, they say that this cable is exceptionally well made and robust. In conclusion, buyers found this to be one of the best splitterbox for daily purposes. The splitter box is a must have accessory for your regular usage. The Ugreen Wii Box offers added strength and flexibility, allowing for easy placement, even in tight spaces. The 2 male rca phono connectors are meant for. Further, this features a corrosion-resistant gold-plated 3.5mm connector and high-quality polished metal connectors. Almost all buyers found that the splitter box is easy to install and use, the sound is synchronized when connected, without delay. They strongly agree that the splitter box is used to send a feed to most stereo amplifiers. Top Customer Quotes:

We looked at 5 other Phono Splitter Boxes. Even though they didn’t make our 5 best Phono Splitter Boxes list, they’re the best of the best and each is still a great option. The information you’ll need to compare each one is included with the listing. Electronically balanced, low impedance, line level outputs. XLR pin1 is ground, pin2 is high, pin3 is low. The 1/4 inch connector's sleeve is ground, ring is low, and tip is high. We recommend balanced connections but unbalanced connections are ok." Almost all buyers opine that the splitter box looks good and feels really well put together. Further, they strongly agree that this cable is good quality and connects the two devices. Multi-purpose phono preamplifier with A/D conversion and 2 output options: Line level and digital optic! Finally, the ugreen wii box provides superior stereo audio transmission and protection against radio frequency interference (rfi) and electromagnetic interference (emi).