About this deal
And then, the next step would be to pull the leads apart at the clips, which happens when you can pull on the tape just then. Most of what's been written above was a complete waste of time because everybody guessed wrongly what you have. If the controller is well made and does not have a large number of registered faults or negative reviews online, then you can safely use it.
eBike Controller - RisunMotor eBike Controller - RisunMotor
However, the wiring patterns going to the connectors may differ from that of the original controller.Resistance test: This measures how much the resistance is, and you can tell there is damage if the multimeter reading is lower than eight kilohms. It is connected to all the other electronic parts such as the battery, motor, and the throttle(accelerator), display(speedometer), PAS or other speed sensors if exist. By doing that, you’ll reduce the heating of the controller and make its operation more stable, which in consequence will increase the reliability of the system. By the motor type, there are brushed DC(direct current) motor controllers and brushless DC motor controllers whereas by their functionality, there is a brushless DC controller with hall sensors.
Controller? How to Remove and Replace an Electric Bike Controller?
I asked if a photo of the controller internals would be helpful-no reply, not even: no, but a photo of. The pins can be removed and installed in different locations on the connector if the connectors are correct but the wiring going to the connectors is incorrect. Thanks for your input chaps, luckily when wiring programmers in the heating sector, I would take before photos to see where cables went, and did the same here. The motor shut down when braking even though other signals taken by the controller at the same time.Most electric bikes can be upgraded to different controllers without any issues as long as it still matches your motor power, this could be to draw more power from the battery, for example, you would need to disconnect all the wires from the previous controller to install the new ones so professional help might be needed.