ALPENFOHN 84000000156 Ventirad for PC

Product Information

Thanks in advance and I will be looking forward for your answer because I feel like playing Sudoku for nearly a month now in my attempt to figure out everything and with 3900X in my scenario … if I am to go eventually with ITX … then Black Ridge is my only true bet! millimeter-thick metal is produced in cooperation with housing specialist Lian Li and contributes significantly to the unmistakable look with a chic hairline finish. Cooling performance of the Alpenfohn Black Ridge was good in comparison to some of the other low profile coolers available on the market. The 92 mm fans are secured by bolts but for the 120 mm you need to use the included clips, depending on thickens of the fan. The Alpenfohn Black Ridge, originally spawned from the legendary mind of Dan from Dan Cases, is a bit of a legend in the small form factor arena.

Surprisingly the R20 test places the ‘exhaust’ 120 mm as the worst performing one while the ‘intake’, again, takes the crown. The original design of the Black Ridge comes from Daniel Hansen, who needed a compact CPU cooler for use in his DAN cases, but also fits perfectly into the Rocket from Kolink. I would say there is a high chance it will fit since if you look at this picture it is flush with the heatsink.This is important because this Black Ridge cooler is made in collaboration with DAN CASES to offer the best performance and versatility possible for this chassis. In the small enclosures strong hardware but must be particularly cooled if it is to run at full speed. To answer you question now … I want to build this as a 2nd pc in a SFF, because it will primarily serve as my streaming rig but also as a multimedia center, living room entertainment but also a mobile work station for editing etc. Also the provided fan is pretty bad and already was making a big of noise since the sticker was falling off. I included the Arctic P14 fan as it fit very nicely on top of either the Blackridge or the L12GE cooler when mounted in my 5.

Also for all scenarios there the side panel will be closed and there will be an extra case fan (Noctua 92mm slim NF-A9x14) set also as an intake. Note for AMD-based systems: Mini ITX motherboards from the manufacturers ASrock, Gigabyte and MSI may cause assembly problems due to the arrangement of the components. I duplicated (almost) the single fan only testing with an Alpenfoehn Blackridge cooler I earlier conducted with a Noctua L-12 Ghost Edition.Non includendo la ventola da 120 millimetri, Alpenföhn, non soltanto ne contiene il prezzo finale, ma lo può pubblicizzarne un’altezza pari a 47 millimetri anzichè 62. inch disk can be accommodated, while under the power supply one (with PSU in SFX-L format) to two (with PSU in SFX format) another 2.

For both scenarios we used the built-in system stability and stress test from AIDA64 and followed by some CPU benchmarks. I stumbled upon your review (walk-through) in my attempt to figure out if Black Ridge will be compatible with Asus Rog Strix B450-i Gaming and thank god You were the exact answer I was looking for. The Alpenfohn Black Ridge is supposed to be the best low profile CPU cooler available right now in 2022. In fact, the Alpenföhn Black Ridge was made in association with Daniel Hansen, the designer of the famed DAN case.But when it comes to efficient, compact enclosures with a micro ATX or even mini ITX core, such as the Kolink Rocket, other qualities are required, such as high cooling performance and particularly quiet operation. The performance is good when taken into consideration the side of the heatsink and the fan used from the factory.